Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Reg:router config

Dear sir,

iam having 2821 router in that iam having nm-8a/s now how can i conform that module is working.can i use one seial port is dce and one moreserial port is dte iam using null modem cable so how can i configure the router.

plz help me.

regards

srinivas.D

1 REPLY
Bronze

Re: Reg:router config

To display hardware and diagnostic information for a networking device, a line card, a processor, a jacket card, or a chassis, use the show diag command in privileged EXEC configuration mode.

show diag [slot-number] [details | summary]

show diag [subslot slot/subslot] [details | summary]

For Null Modem config:

interface serial 0

ip address 10.1.1.1 255.255.255.0

clockrate 44732632

interface serial 1

ip address 10.1.1.2 255.255.255.0

95
Views
0
Helpful
1
Replies
CreatePlease to create content