Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Regarding Password mismatch in 2960 cluster.

I have configured 2960 commander with basic management commands.

Then after typing "rcommand 1", I have configured the first cluster member with same management commands and paswords as in commander , after "copy run start" and coming out of 2960. I am unable to login again to this cluster member because of password mismatch.

Can anyone tell me which password does it take for cluster membership like enable or the password from username...password command.

Thanks.

6 REPLIES

Re: Regarding Password mismatch in 2960 cluster.

It uses the enable password of the remote switch. On the commander, you add "cluster member mac-address password ".

HTH,
John

*** Please rate all useful posts ***

HTH, John *** Please rate all useful posts ***
New Member

Regarding Password mismatch in 2960 cluster.

Hi John,

Your reply is helpful. We have configured only enable secret on cluster member.

after using the command mentioned by you and giving enable secret password the switch is throwing error as:

%ERROR: Member 1 already exists

%ERROR: Cannot add member

Your response will be appreciated.

Thanks.

Regarding Password mismatch in 2960 cluster.

You'll have to remove the existing member. You cannot modify existing member's passwords.

Do a "sh run | i cluster" and find the one that you want to remove. Remove and readd with the password. It should work for you.

HTH,
John

*** Please rate all useful posts ***

HTH, John *** Please rate all useful posts ***
New Member

Re: Regarding Password mismatch in 2960 cluster.

Hi John,

I have readded member in cluster. It is showing in show cluster member output but I am not able to connect to it through

rcommand 1. According to your experience what could be the issue.

Thanks.

Re: Regarding Password mismatch in 2960 cluster.

Post your config...

HTH,
John

*** Please rate all useful posts ***

HTH, John *** Please rate all useful posts ***
New Member

I had had a similar issue.

I had had a similar issue. This syntax worked for me. Thanks John!

"cluster member mac-address 0000.1111.2222 password <YOUR PASSWORD>"

527
Views
24
Helpful
6
Replies