09-12-2013 08:52 AM - edited 03-04-2019 09:01 PM
I have configured 2960 commander with basic management commands.
Then after typing "rcommand 1", I have configured the first cluster member with same management commands and paswords as in commander , after "copy run start" and coming out of 2960. I am unable to login again to this cluster member because of password mismatch.
Can anyone tell me which password does it take for cluster membership like enable or the password from username...password command.
Thanks.
09-12-2013 08:53 AM
It uses the enable password of the remote switch. On the commander, you add "cluster member mac-address
HTH,
John
*** Please rate all useful posts ***
09-12-2013 09:21 AM
Hi John,
Your reply is helpful. We have configured only enable secret on cluster member.
after using the command mentioned by you and giving enable secret password the switch is throwing error as:
%ERROR: Member 1 already exists
%ERROR: Cannot add member
Your response will be appreciated.
Thanks.
09-12-2013 09:34 AM
You'll have to remove the existing member. You cannot modify existing member's passwords.
Do a "sh run | i cluster" and find the one that you want to remove. Remove and readd with the password. It should work for you.
HTH,
John
*** Please rate all useful posts ***
09-12-2013 10:19 AM
Hi John,
I have readded member in cluster. It is showing in show cluster member output but I am not able to connect to it through
rcommand 1. According to your experience what could be the issue.
Thanks.
09-12-2013 10:47 AM
Post your config...
HTH,
John
*** Please rate all useful posts ***
06-18-2014 10:49 AM
I had had a similar issue. This syntax worked for me. Thanks John!
"cluster member mac-address 0000.1111.2222 password <YOUR PASSWORD>"
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide