Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

replacing a WS-X4648-RJ45V-E Module

Hi,

We need to replace one of our WS-X4648-RJ45V-E modules in our Catalyst 4506 switch.  Can I just take out the bad one and put a new one in?  Will it automatically pick up the configuration?  Does the switch need to be restarted?

Thanks

Ron Soulliard

  • WAN Routing and Switching
Everyone's tags (3)
1 REPLY
VIP Super Bronze

replacing a WS-X4648-RJ45V-E Module

Hi Ron,

The blades for the 4500 series are hot swapable.  You should be able to take the old one out and put the new one in the same slot without any issue or needing to restart.

HTH

263
Views
0
Helpful
1
Replies
This widget could not be displayed.