In general, moving from a 7507 to a 3560 might disappoint since they are so different in their orientation. The 7507 was a high end WAN router, the 3560 is a small L3 switch.
I don't believe the base IOS for a 3560 supports BGP. Also believe, the 3560 doesn't support WAN type interface technologies.
Depending on your bandwidth to your ISP, a WAN oriented router might be a better replacement, even a correctly sized ISR. (The latest 3800 series have PPS ratings of the older 7200 NPEs.) If your hand off to/from your ISP is Ethernet, another option might be using a Metro Ethernet switch, e.g. 3750 Metro Series.)
If you are going to use methroethernet P2P link and terminating directly @ to Switch Catalyst switch, It will work well and show best performance. Cisco 6500 switch is best player in metroethernet connectivity.Although
No routers are required with Metro Ethernet connection.
Any multilayer switch( Preferable Cisco) will be suitable for Metroethernet. I will suggest 6500 Multilayer cisco switch
I would not suggest cisco 3560 switch on the metroethernet because Cisco Catalyst 3560 Series is a line of fixed-configuration and enterprise-class switches.This is switch is ideal for access layer in small enterprise LAN access and branch-office environments.I would advice you to use Catalyst 3750 Metro Series switches are premier multilayer switches that intelligence to the metro Ethernet edge and enabling the delivery of more differentiated metro Ethernet services. The Cisco Catalyst 3750 Metro Series offers a cost-effective.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...