I currently have a small 6 site DMVPN setup with 2 Hubs and 4 branch offices. One of the branches routers has failed and I'm going to replace it with a new 1921. I have the old config and have put it on the new router. There were no errors doing so. Is there anything else I need to think about when replacing the router? I'm overly green with DMVPN so I'm not sure what I need to take in to consideration when I'm on site replacing the router.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...