Could someone please approximate how long it would take for WS-X6704-10GE and WS-X6724-SFP to come back online after a "hw-module module x reset" command? If relevant, the router is a 7606-S with redundant RSP720s, the cards have no DFCs and the reason for resetting the cards is fw update from 12.2(14r)S5 to 12.2(18r)S1.
Well, there are currently 6 ports enabled on the WS-X6724-SFP card (5 active, 1 down), and diagnostic bootup level is set to minimal. How long would it take for the card to reset in these conditions? Do I gain much if I temporarily set "no diagnostic bootup level" just for this operation?
The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.
In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.
If firmware is being revised, first reload of the card might take longer than subsequent card reloads.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...