Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Resetting configuration on Catalyst 2900 XL

How do I reset the configuration of a Catalyst 2900 without going through the command prompt?

Thanks,

3 REPLIES
Silver

Re: Resetting configuration on Catalyst 2900 XL

Hello,

If you have an IP address on the 2900 Switch you can use your browser and point it to the URL address http://Switch_IP_address

THere you can reset the configuration.

However, if the switch does not have IP address of the web installed and enabled you have to use the console.

Once in the console issue the below commands

enable

"enter enable password"

wr er

reload

Let me know if this helps,

Appreciate your rating,

Regards,

Community Member

Re: Resetting configuration on Catalyst 2900 XL

Hello,

Is special configuration required for http

Community Member

Re: Resetting configuration on Catalyst 2900 XL

No way to. I can only guess that the reason that you would ask that question is because you do not know the password.

You can find password recovery procedures here:

http://www.cisco.com/warp/public/474/

Cheers.

228
Views
0
Helpful
3
Replies
CreatePlease to create content