Trying to establish a reverse telnet session from my Cisco 2620 router's AUX port to a Cisco 2911 Console port. Each time I try to get the connection to my loopback address I get a response saying "Connection to 192.168.0.42 closed by foreign host". I've gone through tons of knowledge articles and believe I have everything set up correctly unless I'm just missing something easy. Using a flat Cisco roll over cable between the two connections.
2620 Loopback IP: 192.168.0.42 255.255.255.255
2620 Aux port configuration:
line aux 0
exec-timeout 0 0
password 7 14141B180F0B
transport preferred none
transport input all
transport output all
Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int
Trying 192.168.0.42, 2065 ... Open [Connection to 192.168.0.42 closed by foreign host] I figure it'll just be a simple config change to get it going but I'm at a loss. Any help is extremely appreciated!!
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.