Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

RIP Setup Question

I have a test network setup with the following subnet: 10.238.14.0; 10.238.46.0, and 10.238.122.0 all with subnet mask of 255.255.255.0.

How would I setup RIP on all three routers I am using.

Router1 attached to 10.238.14.0

Router2 attached to 10.238.46.0

Router3 attached to 10.238.122.0

I have attached a PDF of the basic layout of the test network I am using.

Thanks for all the help.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: RIP Setup Question

Hi,

include all major networks under "router rip"

router rip

version 2

network 192.168.1.0

network 10.0.0.0

no auto-summary

Also check connectivity (ping) and your routing protocol environment (show ip protocols).

Hope this helps! Please use the rating system.

Regards, Martin

3 REPLIES

Re: RIP Setup Question

Hi,

RIP needs a network statement to tell it, which interfaces should take part in RIP. For all your routers the following config would achieve RIP routing between them:

router rip

version 2

network 10.0.0.0

no auto-summary

Comments:

1) the default is RIPv1 and to change this you need the version command; can be checked f.e. with "show ip protocols"

2) the network statement is always classful even with RIPv2 supporting VLSM

3) In your environment "no auto-summary" does not make a big difference. But just in case you want to include IP addresses from other major networks (class A, B, C) this command is recommended.

Hope this helps! Please use the rating system.

Regards, Martin

Community Member

Re: RIP Setup Question

Ok, I have done that on all three routers but they will not route still.

sho ip route is similar to this on all three.

C 192.168.1.0 is directly connected, serial1

10.0.0.0 is subnetted, 1 subnets

C 10.238.14.0 is directly connected,Ethernet0

Is there something special that needs to be done is all 3 networks are 10.0.0.0 networks

Re: RIP Setup Question

Hi,

include all major networks under "router rip"

router rip

version 2

network 192.168.1.0

network 10.0.0.0

no auto-summary

Also check connectivity (ping) and your routing protocol environment (show ip protocols).

Hope this helps! Please use the rating system.

Regards, Martin

261
Views
5
Helpful
3
Replies
CreatePlease to create content