Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

RIP Timers

Hi,

I have lab with 2600 and mostly 12.1 IOS ..I have used rip v2 in my case and I see the route take around 60-90 sec to disappear from routing table after they get a poisoned route for that destination. I am not modifying any rip timers..and As per boooks it should take 240 seconds..it shows ''possibly down '' for around 1 minute only..but As per books its should be 180 sec..

Any idea..

  • WAN Routing and Switching
2 REPLIES
New Member

Re: RIP Timers

Hi,

you should be able to get some detail if you issue the show ip protocols command.

For example:

Routing Protocol is "rip"

Sending updates every 30 seconds, next due in 27 seconds

Invalid after 180 seconds, hold down 180, flushed after 240

Outgoing update filter list for all interfaces is not set

Incoming update filter list for all interfaces is not set

Redistributing: rip

Default version control: send version 2, receive version 2

Automatic network summarization is not in effect

Maximum path: 4

Routing for Networks:

Routing Information Sources:

Gateway Distance Last Update

Distance: (default is 120)

HTH

New Member

Re: RIP Timers

526
Views
0
Helpful
2
Replies
This widget could not be displayed.