I am trying to complete Phase 2 of the CCNA 4 WAN case study. I have the addressing correct according to what the instructor checked and when comparing to everyone else.
On phase 2, one of the bullets of items to complete is to Configure and redistribute RIP into the OSPF routing process.
After configuring all the routers (Limerick, Belfast, Cork, and Galway) with the appropriate routing protocols, IPs, etc, and then implementing the redistribute commands, I attempt to test the interfaces by pinging them using the IP address of each int.
I've found that I can get to all interfaces except the following:
When pinging from the Galway router to Limerick S0 (172.16.255.249)
from Galway to Belfast E0 (10.0.0.1)
from Galway to Befast S1 (172.16.255.250)
When pinging from the Limerick router to Galway E0 (172.16.4.1)
from Limerick to Galway S0 (172.16.255.245).
If you need any more information, I will be happy to give it. I found this PDF of the Case Study I am referring to.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.