Guy what does ip rip triggered command do..........do we have to config it on both ends.......suppose if we havw two routers and if we config it on one end....will it work....or do we ahve to config on both sides thanks in advance.
This command is configured on links on which you dont want to be sending out periodic broadcasts like RIP (ver 1) would normally do. Eg: WAN links which needs to utilised as per demand (charged per usage).
Triggered updates allow rip to send updates over a link when there has been an update in RIP database, suppressing the normal periodic updates.
So if you have RIP running over a link for which you are charged for usage, you might want to configure triggered extensions. And, yes it should be configured on both ends, otherwise the router at the other end for which triggered extensions is not configured will keep sending out periodic updates.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...