Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

RMON configuration

I would to use RMON to monitor and report on CRC errors for a serial interface and I am struggling to find useful help with the matter.

Also I would like to monitor ipsec over tunnel interfacces so that I can be warned if the tunnels stop being encrypted, not sure if RMON is the right tool.

2 REPLIES
Bronze

Re: RMON configuration

You can create RMON thresholds to monitor CRC Mib Counter and once it hits the threshold, it can send an alert.The only thing that is available is RMON Alert and Traps which use thresholds/mib counters. Once the threshold has been exceeded, you

can the Cisco device send a trap to your chosen destination

New Member

Re: RMON configuration

Hi

Thanks for the reply, I was after some idea on how to capture the information and use it, it is the MIB values that I struggling with, it is proving difficult to tie down the right mib values to use, can you help with that aspect?

Thanks for the thoughts Bob.

117
Views
0
Helpful
2
Replies