A customer has asked us to configure a router for them that was previously used. However the previous engineer has configured a ROM Monitor password. Is there a proceedure to reset the ROM Monitor password? This is a Cisco 805 Router.
I think only TAC can help you to recover this password. I am sure you are in rommon disable mode and to configure anything you can have to come to rommon enable mode and if you don't have the password only TAC can help you.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...