Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

route injection - non redistribution

I am tring  to inject a default route in rip & eigrp without redistrubtion.
two of my routers R3 & R4 must use the default route.

I am succesfull when using a conditon route ( ie: acl+route map -only when network 1.0.0.0 is in R2 route table

but when I try  a eigrp summary + .default-information originate without the condition, it doesnt work

If possible can you tell me what I am missing or doing wrong.

Please don't forget to rate any posts that have been helpful. Thanks.
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: route injection - non redistribution

Hello Pdriver,

the behaviour you see should be correct: RIP cannot generate a default route only because a default route is received in another routing protocol (EIGRP)

when you check for presence of EIGRP prefix  1/8  in IP routing table, RIP generates a default route.

otherwise you would need a static default route in IP routing table

http://www.cisco.com/en/US/docs/ios/iproute_rip/command/reference/irr_rip.html#wp1011008

Hope to help

Giuseppe

1 REPLY
Hall of Fame Super Silver

Re: route injection - non redistribution

Hello Pdriver,

the behaviour you see should be correct: RIP cannot generate a default route only because a default route is received in another routing protocol (EIGRP)

when you check for presence of EIGRP prefix  1/8  in IP routing table, RIP generates a default route.

otherwise you would need a static default route in IP routing table

http://www.cisco.com/en/US/docs/ios/iproute_rip/command/reference/irr_rip.html#wp1011008

Hope to help

Giuseppe

299
Views
0
Helpful
1
Replies