Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Route-Map configuration

Hi all,

What is route-Map ,How we configure in Cisco routers,Pls Provide with Practical scenario,It is urgent,I am Implementing today only,Pls provide inputs

Tnks

Ramu

CMC ltd

2 REPLIES

Re: Route-Map configuration

What is the purpose you want to use route-maps for ?

Here is an example for Policy Based routing with route-map.

http://www.cisco.com/en/US/docs/ios/12_2/qos/configuration/guide/qcfpbr_ps1835_TSD_Products_Configuration_Guide_Chapter.html#wp1001019

Silver

Re: Route-Map configuration

Hi,

A route-map is a very powerfull tool that can be used for a number of purposes, mainly it is used for route-filtering, when perhaps redistributing from one protocol into another, ie ospf into bgp, and you only want some of the routes to be redistributed.

You can also use the route-map to do policy based routing, which allows you to manipulate traffic flow based on source ip address example.

Additionally route-maps can also be used in NAT scenarios when you want to specificy which source ip addresses should be NAT'd.

Check out;

http://www.cisco.com/en/US/docs/ios/iproute/configuration/guide/irp_ip_prot_indep_ps6350_TSD_Products_Configuration_Guide_Chapter.html#wp1056552

http://www.cisco.com/en/US/docs/ios/iproute/command/reference/irp_pi1.html#wp1015665

HTH

LR

396
Views
0
Helpful
2
Replies
CreatePlease login to create content