Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Route map doesn`t match

Dear All,

I have two routers 7500 with 4 E1 leased lines and one E3 link.

I want the voice vlan to go through the 4E1 links only(dedicated links)

I configured :

----------------

On the router at the first site(gateway to the voice vlan)

1)Extended IP access list vc-voice

10 permit ip 10.1.8.0 0.0.0.255 any

2)route-map vc-voice permit 1

match ip route-source vc-voice

set ip next-hop 10.3.15.74

At the other site

-------------------

1)Extended IP access list vc-voice

10 permit ip any 10.1.8.0 0.0.0.255

2)route-map vc-voice permit 1

match ip route-source vc-voice

set ip next-hop 10.3.15.73

The problem

-----------

When I apply "sh route-map"

I found np packet matches at all

I mean all the traffic go through the E3 connection not the dedicated 4E1 links.

Also i want to mention that there is ospf running between the two routers.

router ospf 1

log-adjacency-changes

redistribute static subnets

network 10.3.15.0 0.0.0.255 area 0

network 10.5.20.66 0.0.0.0 area 0

maximum-paths 6

default-information originate always

So could anyone help me in this issue.

Thanks...

Best Regards,

Kareem Ismail

3 REPLIES
Silver

Re: Route map doesn`t match

You have used 'match ip route-source'. Shouldn't you be using 'match ip address' instead.

Thanks.

Re: Route map doesn`t match

HI

Can u try this

)Extended IP access list vc-voice

10 permit ip any 10.1.8.0 0.0.0.255

2)route-map vc-voice permit 1

match ip address 10

set ip next-hop 10.3.15.73

Thanks

Mahmood

New Member

Re: Route map doesn`t match

Dear All,

Thanks a lot for your cooperation.

It has been solved.

By the way there is a missing command:

ip policy route-map .....on the input interface

Thanks...

Kareem Ismail

130
Views
0
Helpful
3
Replies
CreatePlease login to create content