Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

route-map isdn

Hi

i have isdn backup link leased line and i use route-map policy to route packet out. when link leased line down , isdn will connect to backup but in truth when my leased line down (line protocol down) isdn backup not call connect . i try to do everything but it's not work!!, i think my route-map may be not know the leased line link down. Could anyone help me to prove this problem .

i have two IP groups that is 192.168.xx.xx and 172.31.xx.xx

i use route-map to route source ip 192.168.xx.xx to ISP#2 and 172.31.xx.xx route to ISP#1 and i use dialer1 to backup isp#2 and dialer2 backup isp#1

(my isp#1 is serial1/0 and isp#2 is serial0/0)

access-list 10 permit 192.168.0.0 0.0.255.255

access-list 11 permit 172.16.0.0 0.15.255.255

!

dialer-list 1 protocol ip permit

route-map isp permit 10

match ip address 10

set interface Serial1/0 Dialer1

!

route-map isp permit 20

match ip address 11

set interface Serial0/0 Dialer2

!

thanks

1 REPLY
VIP Purple

Re: route-map isdn

Hello,

can you post the full configuration of your router ?

If your ISDN is never triggered, the route maps won´t work...

Regards,

GP

107
Views
0
Helpful
1
Replies
CreatePlease to create content