I'm trying to do some redistribution of bgp into eigrp in gns3.
This works fine, redistributing bgp into eigrp, I can see all my routes. router eigrp 1 network 10.2.2.0 0.0.0.255 redistribute bgp 65501 metric 100 1 255 1 1500
When I add the route-map to the redistribute statement, all eigrp routes are filtered out, not just the one in the prefix list. I don't see what I'm doing wrong, if you can point me to some good links that I can read up on, that would be great. ! route-map BGP2EIGRP deny 10 match ip address prefix-list novoip_plist ! route-map BGP2EIGRP permit 20
ip prefix-list novoip_plist seq 50 deny 10.10.10.0/24
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...