Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

route maps

can any body explain why we give route maps configuration

2 REPLIES

Re: route maps

HI Philip, [Pls RATE if HELPS]

To define the conditions for redistributing routes from one routing protocol into another, or to enable policy routing, use the route-map command in global configuration mode and the match and set command in route-map configuration modes. To delete an entry, use the no form of this command.

route-map map-tag [permit | deny] [sequence-number]

no route-map map-tag [permit | deny] [sequence-number]

Examples

========

The following example redistributes Routing Information Protocol (RIP) routes with a hop count equal to 1 into Open Shortest Path First (OSPF). These routes will be redistributed into OSPF as external link-state advertisements (LSAs) with a metric of 5, metric type of Type 1, and a tag equal to 1.

router ospf 109

redistribute rip route-map rip-to-ospf

route-map rip-to-ospf permit

match metric 1

set metric 5

set metric-type type1

set tag 1

Hope I am Informative.

PLS RATE if HELPS

Best Regards,

Guru Prasad R

New Member

Re: route maps

131
Views
0
Helpful
2
Replies
CreatePlease to create content