Route traffic comming inside the WAN to outside the WAN(Same interface)via IPSec tunnel
This is our test setup. Any source will hit the ASA5505 Wan interface to a public IP lets say 184.108.40.206. We need to NAT this IP 220.127.116.11 to a local IP of the other side of the LAN (behind Linux firewall) lets say 172.17.100.2 (18.104.22.168 <==>172.17.100.2). How can we do that? Interesting traffic of the IPSec is trafficc generated between 192.168.0.0/16 and 172.17.100.0/24.
So simply what we need to do is when a user hits to the 22.214.171.124 the destination IP of the request should be changed to 172.17.100.2 and the source IP of the request shuold be changed to 192.168.0.0/16 range IP and request shuold be forwarded out of the WAN interface so that traffic will be intersting traffic of the IPSec and will go to the required destination via IPSec tunnel.
We need to know whether this is possible and any help from any one of you will be highly appreciated.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.