Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Routed ports and EHWIC-D-8ESG-P

Hello,

We have a 2921 with a EHWIC-D-8ESG-P module for service to a local telecom closet.  The building is being serviced by two switches connected to a gig port with subinterfaces.  Is there a way to use the subinterfaces defined on the gig port on the EHWIC-D-8ESG-P module?

 

R1#sh ip int bri
Interface                  IP-Address      OK? Method Status                Protocol
Embedded-Service-Engine0/0 unassigned      YES NVRAM  administratively down down
GigabitEthernet0/0         172.16.1.190    YES NVRAM  up                    up
GigabitEthernet0/1         unassigned      YES NVRAM  up                    up
GigabitEthernet0/1.101     10.100.49.1     YES NVRAM  up                    up
GigabitEthernet0/1.201     10.200.49.1     YES manual up                    up
GigabitEthernet0/1.501     172.22.4.1      YES NVRAM  up                    up
GigabitEthernet0/1.551     172.26.4.1      YES NVRAM  up                    up

 

  • WAN Routing and Switching
Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Hi dpita, I don't think you

Hi dpita,

 

I don't think you can create subinterfaces on the EHWIC-D-8ESG-P as the ports are layer 2 but an alternative is to create SVIs for each subinterface or subnet and then trunk it to the switch via one or bundle of ports from the EHWIC module.

 

Hope this helps.

 

 

2 REPLIES
New Member

Hi dpita, I don't think you

Hi dpita,

 

I don't think you can create subinterfaces on the EHWIC-D-8ESG-P as the ports are layer 2 but an alternative is to create SVIs for each subinterface or subnet and then trunk it to the switch via one or bundle of ports from the EHWIC module.

 

Hope this helps.

 

 

New Member

Thanks!I ended up removing

Thanks!

I ended up removing the EHWIC since we needed a fiber link and no one wanted to buy a media converter to use the EHWIC.  

187
Views
0
Helpful
2
Replies