Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Router 1601 interface problem

I tried to configure my modem for loopback mode however line protocol is still down. Change another router and line protocol goes up (looped) same config. Need to know how to veriy that the serial interface is indeed defective.

2 REPLIES

Re: Router 1601 interface problem

hi

can u revert about the wan protocol being used in the earlier one and in the new router ?

is it ppp or hdlc ? being used in ur boxes ?

and also the type of the card like wic-2t or NM series module ?

Also the ios code being used in routers ?

have u tried in same kinda (1601) router or with some other model ?

regds

New Member

Re: Router 1601 interface problem

Issue "sh int s0/x" and check the DTR & RTS (dte-dce syncronization) if it is up, if not, probably your serial is defective.

regards

-john-

88
Views
0
Helpful
2
Replies