Re: router 1712, ip routing based on destination port
Anthony is correct that there is not any option in the ip route command to make the routing decision based on the TCP or UDP port number. But it is possible to do this kind of thing with Policy Based Routing. He gives a pretty good example of PBR. One detail that he did not include is that you must configure PBR on the inbound interface where the traffic arrives to the router.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...