The ip helper-address command is used when the DHCP is on some device other than the router. When DHCP is configured on the router itself then you do not need ip helper-address.
The config parts that you posted look like a reasonable start for DHCP on the router. I would think that you might want to also configure to exclude the router address from the pool of addresses. Is DHCP working or not working based on what is in your config so far?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.