I have a freash router 1841 at its serial interface i configured for E1 link but it atumaticlly shows clock rate of 2000000 this . I tried to remove it i am unable even i have change its IOS and erase the NVRAM and reconfigurd it
but always it shows clock rate 2000000
,but i can change the rate but unable to ' No clock rate 'can anyone help me to remove clock rate
if you are not using the serial interface then it wont do anything. if you are using the serial interface, and are acting as the DCE (pretty sure its DCE and not DTE) then you must use clockrate command. It is used when you are providing clocking on a serial interface to link up a connection. Normally, the router will determine if you are using a DCE or DTE connection and use the clockrate if it is needed. if there is no connection, then the default is to show the clockrate command, I believe.
basically, if you are not using the interface, then it doesnt hurt to leave it in. if you are using the interface, then it needs to be set to the right value.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.