Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Router 1841 don´t charge

I have a problem with a router 1841 because a student erase the cisco ios, but, don´t charge the rommon, only see symbols when i use the console cable,

thanks for your help.

i see this simbols: router error.JPG

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Router 1841 don´t charge

héllo

try changeing the baud rate in hyperterminal to different values (9600 default, try 115200)

i have faced similar problem when student put a  not-classic conf-reg,

bye

4 REPLIES
New Member

Re: Router 1841 don´t charge

The settings in the Hyper Terminal need to be set correctly; otherwise, "strange-looking" or garbage characters may show up on the screen. When you set up the connection, use these settings:

Bits per sec    :  9600 
Data bits       :     8 
Parity          :  none 
Stop bits       :     1 
Flow control    :  none 
New Member

Re: Router 1841 don´t charge

héllo

try changeing the baud rate in hyperterminal to different values (9600 default, try 115200)

i have faced similar problem when student put a  not-classic conf-reg,

bye

Hall of Fame Super Gold

Re: Router 1841 don´t charge

Right-o.  Go back into ROMmon (by removing the CF and booting the router without the CF) and type the command "unset BAUD".  Make sure the "BAUD" is in all caps the "unset" is in lower caps (use Notepad).  Once this is done, reboot the router.  Make sure you give the student an "F" or something.    He he he ...

New Member

Re: Router 1841 don´t charge

thank´s it works with a baund of 57600.

486
Views
0
Helpful
4
Replies
CreatePlease to create content