Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Router 2951 with Multilink ppp

We just fired up a new 2951 with 7-T-1's and the lantency is just horrible. We have called the telco and they say they see no errors, but when we ping and tracert we hot 1000ms to 3000ms to our MPLS network. Also when we hit the multilink serial MPLS connect we see the 1000 to 3000ms leg times. That interface it local to the router. I have copied out config as well.

Any help would be apperciated.

Dan          

1 ACCEPTED SOLUTION

Accepted Solutions
Green

Router 2951 with Multilink ppp

Hi,

It is my understanding that Interleavining and fragmentation

should only be used on circuits less than 768K.

Try removing

!

interface Multilink 1

no ppp multilink interleave

no ppp multilink fragment disable

!

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.
2 REPLIES
Green

Router 2951 with Multilink ppp

Hi,

It is my understanding that Interleavining and fragmentation

should only be used on circuits less than 768K.

Try removing

!

interface Multilink 1

no ppp multilink interleave

no ppp multilink fragment disable

!

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.
Community Member

Router 2951 with Multilink ppp

Ended up being a bad vwic port, but thaanks for the responce.

153
Views
0
Helpful
2
Replies
CreatePlease to create content