Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Router 3660 not sensing 16 port A/S Module .

Hi , i am facing a typical problem that cisco 3660 is not able to activate the 16 port A/S Module .

Following is the Message i get when the router boots !!

16 A/S is in slot 2 and is a new module .

MEMINIT: No iomem table entry for pa type 0x391 in slot2

3660 Chassis type: ENTERPRISE

1 FastEthernet/IEEE 802.3 interface(s)

DRAM configuration is 64 bits wide with parity disabled.

125K bytes of non-volatile configuration memory.

8192K bytes of processor board System flash (Read/Write)

00:00:04: %PA-2-UNDEFPA: Undefined Port Adaptor type 913 in bay 2

00:00:04: %PA-3-DEACTIVATED: port adapter in bay [2] powered off.

IOS Version :

Cisco Internetwork Operating System Software

IOS (tm) 3600 Software (C3660-D-M), Version 12.1(21), RELEASE SOFTWARE (fc1)

What may bethe problem ? Pls help ?

2 REPLIES

Re: Router 3660 not sensing 16 port A/S Module .

Hi Murthy

AFAIK you need to upgrade the current ios code so that your router can recognize the card.

regds

Re: Router 3660 not sensing 16 port A/S Module .

You need atleast Cisco IOS Release 12.2(15)ZJ or Release 12.3(2)T or a later release to run this module on 3660 router.

http://www.cisco.com/en/US/partner/products/sw/iosswrel/ps5207/products_feature_guide09186a0080181b66.html#1027188

http://www.cisco.com/en/US/products/hw/routers/ps274/products_qanda_item09186a00801850cd.shtml

HTH,Please rate if it does.

-amit singh

116
Views
9
Helpful
2
Replies