I'm configuring C3660 for PPPoE subscribers. I'm just trying to use feature ârange [range-name] pvc start-vpi/start-vci end-vpi/end-vciâ under ATM interface configurations.
Router(config)#interface atM 1/0.4 multipoint
Router(config-subif)# Here I can't find ârangeâ command.
I tried different IOS version 12.2 and 12.3, but it did not help. I'm running now with c3660-telcoentk9-mz.123-22.bin. Can someone please confirm the support of range command under ATM interface in 3600 series routers.
In case I just want to use range command feature under ATM configuration. Is it necessary to get 12.2SB. ATM range command feature is an important feature and I would it should not be with specific release.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...