Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

router 3825 performance

Dear All

I took the following note from cisco site

Wire-speed performance on 3825 with services enabled at up to T3/E3 rates.

my quiestion is.

does this apply if i use Cisco Gigabit Ethernet Network Module to connect it to my service provider, in other words, can i get 1 GIGA throuput out of the router despite the upper statement using the GIG NM or using the SFP placed on the router.

3 REPLIES

Re: router 3825 performance

The 3825 has a Switching capacity of 179 Mbps or 350,000 pps under ideal conditions.

I think you can safely load the router till the above value

Have a look at the attached document

HTH, rate if it does

Narayan

Hall of Fame Super Silver

Re: router 3825 performance

Emad

If it is rated for wire speed up to T3 (45 meg) then I would not count on getting wire speed using a Gig interface. The performance of the router is somewhat dependent on what you are asking it to do (how many services you enable on it) but I would not expect to get wire speed performance on the Gig interface.

HTH

Rick

New Member

Re: router 3825 performance

Thank you for the helpfull answer, is there document or link describing in more details these performance issues on routers and switches.

297
Views
8
Helpful
3
Replies