Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Router 800 series support loadBaland and failover ?

dear All,

Could you let me know please!!!

I would like to know on Router 800 series can support loadbalance and failover or not?

Best

3 REPLIES

Re: Router 800 series support loadBaland and failover ?

Hi David

what kinda load balance and failover you are looking at ?

can you be more specific about the requirement you have out there in your network ?

regds

Community Member

Re: Router 800 series support loadBaland and failover ?

dear Spemkumar,

Thanks you for your question.

i would like to know this product can suppport load banland and failover or not?

Load Balance ( i mean i have 2 ISP and the both ISP share 50%) and failover ( i mean i have 2 ISP and ISP1 active and ISP2 Backup whne the ISP1 down, ISP2 will be up automatic)

Best Regards,

Rechard

Re: Router 800 series support loadBaland and failover ?

hi david

if you are looking at load balance with routing protocols such BGP then i dont think 800 series will be able to do that.

But as far as redundancy/failover is concerned with 2 ISP and with NAT options you can do with 800 series routers.

With normal NAT and 2 ISPs i dont think you will be able to get the desired result of load balancing.

But i think you can segment your local lan network and do a policy based NAT which can take care of your loadbalancing (one segment of your lan using ISP1 and the other segment using ISP2).

regds

regds

117
Views
0
Helpful
3
Replies
CreatePlease to create content