Re: Router 827 - Can't get Nat working properly to webserver
Can you advise the result w/o the parameter of "extendable" in NAT statment ?
Moreover, can you try below ?
ip nat outside source static tcp x.x.245.114 80 192.168.100.10 80
And, did you confirm your web server use only TCP port 80 ? Will it also use other port ? If it still not work, try to use static NAT (w/o tcp & port no.) to test and verify it works then add the port back.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...