I´m having trouble connecting to the internet with the 877 router; I have tried several different configurations, but I always fail to connect. The Telecom said that the line is Ok, and in fact I´ m able to connect through the old Alice modem I have, even with a good bandwidth (6.5 Mbps in download). But when I try to use the 877, it fails. I was wondering whether it has to do with the attenuation: usually it is around 12 dB, as shown here below. But in my case it´s around 32dB. Can this be the reason ? or do I have to did deeper in my config file ?
router#sh dsl int ATM0 Alcatel 20190 chipset information ATU-R (DS) ATU-C (US) Modem Status: Showtime (DMTDSL_SHOWTIME) DSL Mode: ITU G.992.1 (G.DMT) Annex A ITU STD NUM: 0x03 0x1 Vendor ID: 'STMI' 'TSTC' Vendor Specific: 0x0000 0x0002 Vendor Country: 0x0F 0xB5 Capacity Used: 100% 60% Noise Margin: 11.5 dB 23.0 dB Output Power: 14.5 dBm 13.0 dBm Attenuation: 12.0 dB 3.0 dB Defect Status: None None Last Fail Code: None Watchdog Counter: 0xF5 Watchdog Resets: 0 Selftest Result: 0x00 Subfunction: 0x00 Interrupts: 8093 (0 spurious) PHY Access Err: 0 Activations: 2 LED Status: ON LED On Time: 100 LED Off Time: 100 Init FW: init_AMR-2.6.004.bin Operation FW: AMR-2.6.004.bin FW Version: 2.6.4
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.