router and interface selection to support 10xE1 links (Drop and Insert)
Our HQ is connected to the branch offices with at least 10xE1 (all P2P links). They are used to connect the PBXs at the moment. We want to add the data service, what router model and interface cards should we use? Based on my search we need at least 10 "VWIC2-2MFT-G703" cards which support the "Drop and Insert" feature that allows the cuncurrent use of the E1 link for our current PBXs as well as the new DATA (WAN) service (e.g. 15 time slots (TS) assigned to the PBX voice traffic and 15 TS assigned for data (WAN) service). I would like to know which router has such interface capacity? Is there any other solution? What about the performance issues?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...