Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Router as Frame Relay Switch

Hello,

I have a cisco 2620 and a 4nm async/sync acting as frame relay switch. I have the connections setup but what I'd like to do is set the switch (router) up to send fecn/becns once the traffic reaches a certain limit. Basically I want to set the CIR on the frame switch and enforce it similar to what a provider would do.

Thank you.

Dan Cox

4 REPLIES
Hall of Fame Super Gold

Re: Router as Frame Relay Switch

Sorry, CIR and congestion management is not supported on the frame-relay switching feature.

Hope this helps, please rate post if it does!

Re: Router as Frame Relay Switch

Hi,

I don't think that this can be done on a Cisco router acting as a frame relay switch,

HTH, please rate if it does help,

Mohammed Mahmoud.

Re: Router as Frame Relay Switch

Hi, Dan

Don't give up anyway. There is an old book called : Cisco Frame Relay Solution Guide.

You may find your answer on this book, chapter 6, "Configuring Frame Relay Switching Enhancements on a Cisco Router"

There are some configuration examples on topics you have mentioned. Have a look at this site:

http://safari.adobepress.com/1587051168/ch06lev1sec3

Good Lucks

SSLIN

Hall of Fame Super Gold

Re: Router as Frame Relay Switch

Good finding. I kind of remember, shaping and policing are supported, but not congestion notification...

321
Views
0
Helpful
4
Replies