Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

router boots into (boot) mode

Config-register is set to 0x2102.

when I pull the PCMCIA out and reload the router, it come up in boot mode.

This is really bad and I would prefer it boot into rommon> and loos all functinality. rather that have some features but not others.

Is there a register setting that will force the router with no valid image to go into rommon instead of boot mode?

1 REPLY
Purple

Re: router boots into (boot) mode

Hi Todd,

I don't believe there is any setting that will allow you to do so. The router will always fall back to the boot image, if one is available.

Hope that helps - pls rate the post if it does.

Paresh

108
Views
3
Helpful
1
Replies
CreatePlease to create content