Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Router can not boot up after inserting T3 card

Hey All,

Router hung after inserting a new T3 card, we tried to remove the T3 card, but still can not get the router reboot properly, it just shows below 3 lines message.

System Bootstrap, Version 12.2(4r)B2, RELEASE SOFTWARE (fc2)

TAC Support: http://www.cisco.com/tac

Copyright 2002 by cisco Systems, Inc.

2 REPLIES
VIP Purple

Re: Router can not boot up after inserting T3 card

Hello,

can you get into ROMMON (press Ctrl+Break after powering on the device) ? If so, at the ROMMON prompt, type:

rommon>config-register 0x2142

and then:

rommon>reset

This will reset the configuration of your router to the initial defaults. If you are able to boot the router afterwards, don´t forget to set the configuration-register value back to 0x2102 (otherwise the router will boot to default values every time it is started)...

Let me know if this helps, if not, we will need to try something else...

Regards,

GP

New Member

Re: Router can not boot up after inserting T3 card

Hi GP,

Thanks for your reply, the problem has been resolved.

Thank You,

Regards,

Trina

90
Views
0
Helpful
2
Replies
CreatePlease to create content