Hello, I am not a routing professional of any sort so please bare with me.
I am looking for a lower cost Cisco router that is capable of routing multiple static WAN IPs to predetermined local IPs (the specific webserver(s) and associated virtual IPs set for a single NIC on each server).
I currently have a 2600 series router with two WIC T1 cards, but I am not ready to utilize the T1 service yet (budget). I am currently using DSL, but I cannot find a WIC-1ADSL card that will fit my small budget. This is why I am looking for a lower cost and maybe even used router that can do what I need.
I am only running 1 webserver with virtual hosting under 1 wan ip from the ISP. Obviously this restricts me to only 1 SSL site. I am about to purchase a large block of static IPs from the ISP as soon as I figure out a router solution.
I am not aware of any such restriction of NAT setup on the 800 series. You will just configure one static NAT statement for every one of your servers, and you would configure overload NAT for your users.
I found a WIC1-ADSL for my 2651 as a solution rather than getting an 800 series. Unfortunately, the version IOS in the 2651 does not support the WIC card. Short of paying for support in order to get an upgraded version, I am looking at the 800 series again.
I have DSL, PPPoA (ISP), and the need to route multiple static WAN IPs to the respective LAN IPs.
With these requirements in mind, could anyone recommend one of the 800 series routers on eBay that would work?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.