Re: Router going to ROMMON after IOS update but then boots with
Since you are able to boot the router using the new IOS image there's nothing wrong with the image. It appears the config register setting may be causing this. Can you verify whether the config register is set to 0x2102. Moreover, if you have a 'boot system' command in the configuration that's pointing to the old IOS image then remove it and make it to the point to the new IOS image or just don't leave any boot system commands in the config.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...