I have looked at the config that you posted and I notice that both of the physical interfaces are shut down. When you attempt to configure OSPF it attempts to establish its Router ID using an IP address from one of the interfaces. But with the interfaces shut down it can not allocate its RID and that causes the process to not start and not show up in show run. I suggest that you no shut one or both of the interfaces and then try OSPF again.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...