Some additional detail would be very helpful. What kind of routers are these that you want to connect to the 7206? What kind of interface on these routers and what kind of interface on the 7206? Did you do a no shutdown on both of the interfaces? Did you do any configuration on the router interfaces? If so, what did you configure?
It would also be helpful if you would post the output of show ip interface brief from the 7206 and one of the other routers.
I had this same exact issue this week. I have 2 7206VXR's with G2 sup modules and I was trying to connect the two routers together via the Gi0/1 copper ports. I could not get the protocol to come up. I tried multiple crossover cables and multiple straight through cables with no success. Finally, I changed the media-type on the interface to SFP and hooked the two up with fiber and the interface came up right away. I had never had this issue before but I didnt troubleshoot it anymore. I just left the connection on fiber.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.