Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Router to Router is slow

Dear All,

Coul you find the problem, i had two router 1721,wic-1T and V.35.Then i connected router 1721 to 1721 by V.35(not lease line or vpn, it simple connect),and I use protocol eigrp 50 for routing.After I configure already in router , i can ping PC to PC cross by router but when i transfer data 2 MB it very slow and take time.

Best Regard,

3 REPLIES
New Member

Re: Router to Router is slow

Hi

Try to do an Extended ping;than when u reach the DataGram Frame increse it first to 1Mbps,and see the result!

10xs

New Member

Re: Router to Router is slow

Hello

Could you tell me how slow it is and how much time it takes?

What is the clockrate on the serial link?

Dou you see CRC's on the "show interface x"?

An other question. Why use a dynamic routing prot on a B2B situation?

Ciao

New Member

Re: Router to Router is slow

Dear Sir,

Sorry for reply late.

1.when i send 2 MB it take 2minute.

2.I set Clock Rate 64000.

3.Why use a dynamic routing prot on a B2B situation?

+The answer: Now the real system using dynamic routing. I had test route stastic also.

Best Regard,

98
Views
0
Helpful
3
Replies