Router-to-router with tunnel doesn' work!

[conectividade]

Hi, Messrs!

I would like your help! A connection router-to-router with tunnel doesn't work with IOS C3745-ADVENTERPRISEK9-M, Version 12.3(14)T7 and C3745-JK9S-M, Version 12.3 (6a). What could be wrong?

So many differences betwen versions?

What could I do, to do this work?

Attached I send you my config, the other side can't send me a config.

thanks in advance,

Renato

[mbacklund2]

I think the problem is at line

match address SERVER-CLI

SERVER-CLI don't match to anything in your config. Write a named access-list that match the IP source and/or destination

which should trigg to open the VPN connection.

Take a look in the documentation bellow. That would hopefully help you more.

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a008009448f.shtml

[jackyoung]

If you ensure the access-list is correct for SERVER-CLI, try to remove access-group 170 in/out from s0/0.1 for test.

A full config. can help more.

Hope this helps.