Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Router Upgrade/Migration

I will be upgrading router hardware from a 2821 to a 2851 ISR. Will it be possible to just upload the existing config from the 2821 to the 2851 as-is? Will there be any additonal changes will I need to make to get going?

Thanks! Will rate post.

2 REPLIES

Re: Router Upgrade/Migration

Sort of. The interface number scheme will be different. What interfaces (ie Serial) do you have in place today? Most likely the interfaces will be different, but the configuration under the interface will be the same or very close.

New Member

Re: Router Upgrade/Migration

OK. I have 2 Gigabit Interfaces, a channelized T1/PRI (24 Serial Ports), 4 FXO, 4 FXS ports.

So if I upload the config, the parts that aren't applicable will just error out, but the rest should load no problem? I know you don't have all of the information, I am just trying to determine how difficult the transition will be. Any insight is appreciated.

226
Views
0
Helpful
2
Replies