Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Router with 2 interface

Hello

I would like to confirm if the following scenario is possible?

I have a Cisco 2821 router. It has 2 interfaces. The first interface (GE 0/0) connects to the internet and NAT'ing is performed on the interface. This interface allows for the office employees to have internet access.

The second interface (GE 0/1) on the same Cisco 2821 connects the same office employees to a 10.230.0.0/16 WAN.

Is this possible? And what gotchas are there that I should be looking out for?

Many Thanks

wvw

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Router with 2 interface

100% possible

what u need is to make correct routing

lets say ur remote site over the WAN has network as 192.168.1.0/24

and u dont use any dynamic routing with ur remote site

u need first static route point to ur remote site through the WAN and lets say the remote router over the WAN is 10.230.0.1/16

ip route 192.168.1.0 255.255.255.0 10.230.0.1

now u need a defualt static route for internet like;

ip route 0.0.0.0 0.0.0.0 Ge0/0

or

ip route 0.0.0.0 0.0.0.0 [next hop IP for internet]

good luck

if helpful Rate

2 REPLIES

Re: Router with 2 interface

100% possible

what u need is to make correct routing

lets say ur remote site over the WAN has network as 192.168.1.0/24

and u dont use any dynamic routing with ur remote site

u need first static route point to ur remote site through the WAN and lets say the remote router over the WAN is 10.230.0.1/16

ip route 192.168.1.0 255.255.255.0 10.230.0.1

now u need a defualt static route for internet like;

ip route 0.0.0.0 0.0.0.0 Ge0/0

or

ip route 0.0.0.0 0.0.0.0 [next hop IP for internet]

good luck

if helpful Rate

New Member

Re: Router with 2 interface

Thank you so much for the help, Marwan :)

182
Views
0
Helpful
2
Replies