There is a lease line with two 2801 routers. it has 4 slots ,if wic-2t card is connected to one slot, ping rate is good, if it is connected to some other port, full of drops, if the same wic-2t card is connected to some other router,it is working fine.
1.wic-2t card is not a problem since it is working fine in two slots.
2.IOS is also not a problem.
3.Only suspected is router.
But router is new , which has come from cisco yesterday.
Not all slots have the same functionality. Two of them are HWIC slots. What I would like to know (if I were you) is wheter the two slots that the module works with are the HWIC-slots, the other two or any other combination.
Case 1 and 2 could indicate IOS issues, the latter one would rather point to a hardware issue.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...