I have searched for 2 days trying to find information on this subject. I have a 2851 router with an AIM-COMPR2-V2 module. The software level is 15.1(4)M7. We have point-to-point T1 between two of the exact same routers. I would like to run payload compression, use the AIM module, and enforce a QOS policy on the interface. The "Show Compress" command counters will not increase as long as the interface has the "Service-Policy Output" command on it. I found several articles that discuss that as an issue before 12.X versions of software, but I can't find anything newer.
Should this work? If not, where can I find the most recent documentation as to why it won't? Also, if not, what is my best option in the given scenario?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...