Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Routing beetween company branches

I have 6 routers like on this configuration:

routing.PNG

First I want to connect from LAN of the routers rout 1,2,3 to the servers (192.168.179.4-9) behind CH2.

For second I want to connect from LAN rout 1 to the computers in the LAN rout 3 and rout 2.

How configure routing ?? Shoud I use static or can I use dynamic (Cisco 871) ???

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Routing beetween company branches

First I want to connect from LAN of the routers rout 1,2,3 to the servers (192.168.179.4-9) behind CH2.

For second I want to connect from LAN rout 1 to the computers in the LAN rout 3 and rout 2.

How configure routing ?? Shoud I use static or can I use dynamic (Cisco 871) ???

Hi ,

As you know static routing is configured by the network administrator and is not capable of adjusting to changes in the network without network administrator intervention. Dynamic routing adjusts to changing network circumstances by analyzing incoming routing update messages without administrator intervention.

So better to go with dynamic routing protocol configuration,check out the below link

http://www.cisco.com/en/US/docs/routers/access/800/850/software/configuration/guide/routconf.pdf

Hope to Help !!

Ganesh.H

Remember to rate the helpful post

3 REPLIES
Cisco Employee

Re: Routing beetween company branches

I think dynamic routing protocol would be better as that will ensure shortest path to the destination. Also, it will provide redundancy in case one of the links fail. Seems like 871 certainly supports RIP (V1/V2). So, that should not be a problem. Only thing you need to make sure is that you run the routing protocol over the VPN tunnel to ensure proper network convergence.

Hope this helps.

Regards,

NT

Note: Please do not forget to rate useful posts.

Re: Routing beetween company branches

First I want to connect from LAN of the routers rout 1,2,3 to the servers (192.168.179.4-9) behind CH2.

For second I want to connect from LAN rout 1 to the computers in the LAN rout 3 and rout 2.

How configure routing ?? Shoud I use static or can I use dynamic (Cisco 871) ???

Hi ,

As you know static routing is configured by the network administrator and is not capable of adjusting to changes in the network without network administrator intervention. Dynamic routing adjusts to changing network circumstances by analyzing incoming routing update messages without administrator intervention.

So better to go with dynamic routing protocol configuration,check out the below link

http://www.cisco.com/en/US/docs/routers/access/800/850/software/configuration/guide/routconf.pdf

Hope to Help !!

Ganesh.H

Remember to rate the helpful post

New Member

Re: Routing beetween company branches

Thanks for suggestions.

271
Views
8
Helpful
3
Replies